Citronic CDM8:4s, Руководство пользователя

Страница: 4 / 10

™
5. Microphone EQ Controls
Both microphone inputs share a 3 Band Eq stage prior to the ON AIR switch.
EQ Control ‘Lo’
This control allows 12dB of cut or boost to the low frequencies.
EQ Control ‘Mid’
This control allows 12dB of cut or boost to the mid frequencies.
EQ Control ‘Hi’
This control allows 12 dB of cut or boost to the high frequencies.
6. On Air Switch
Activates or de-activates both microphone inputs without the need to adjust the Gain controls.
7. Manual Override Switch
When this switch is held down the music channels will be attenuated by 15dB.
Music Channels Section
8. Input Select Switch
This control selects the input source for its respective channel. Channels 1, & 4 are Line or Phono, channels
2 & 3 are CD or Line switchable.
9. Input Gain Controls
Each main input channel has a gain control offering <-70 to +10dB gain range allowing compensation for
differing input levels.
10. 45mm Input Fader
The slider sets the signal level of the channel being mixed onto the main Left, Right Output channels or sent
to the assignable Crossfader.
11. Music Channel EQ Controls
Each music channel has a 3-band Eq stage providing comprehensive control over individual input Eq
content.
EQ Control ‘Lo’
This control allows 12dB of cut or boost to the low frequencies.
EQ Control ‘Mid’
This control allows 12dB of cut or boost to the mid frequencies.
EQ Control ‘Hi’
This control allows 12dB of cut or boost to the high frequencies.
Crossfader Section
12. 45mm Crossfader
This dipless 45mm crossfader is dedicated between either CH.1 or 2 and CH.3 or 4 dependent on the
setting of the assign switches. (13&14)
The crossfader is easily and quickly replaced by removing the 2 outer pozi countersunk screws on the
crossfader panel and unplugging attached ribbon connector.
13. Channel 3 & 4 Assign Switch
This switch will assign either channel 3 or channel 4 to the right-hand side of the crossfader.
14. Channel 1 & 2 Assign Switch
This switch will assign either channel 1 or channel 2 to the left-hand side of the crossfader.
15. Crossfader Defeat Switch
When depressed the crossfader is disabled and all 4 music channels will act independently.
Note: When the crossfader is disabled the overall output level will be slightly higher so level controls such as
gains and channel faders may need to be adjusted to maintain the optimum running level.
Music Monitoring Section
16. Input Cue Switch
The pre-fade input signal from each of the four main music channels can be routed to the headphone and
when selected the VU display section of the mixer.
17. Monitor Pan Fader
Varies the mix between the cued input and main L, R output, ideal for accurate beat mixing. Full left will
give cued input; full right will give main output program.