(4) Pressing button
A
during measurement forcibly
interrupts timing and returns the watch to the
initial set time (flyback) after the timer begins to
count down again.
* If the watch is switched to a different mode while
in the initial timer set time, the timer is running,
the timer is stopped or in the autochronograph
mode, and then is switched back to Timer 2
mode, the watch will display each state as it was
prior to switching to the other mode. However, the
watch will switch to the Timer 2 initial set time
after timer measurement is completed.
10. EL Internal Illumination Function
Electroluminescene (EL) refers to a scientific
phenomenon in which an EL material emits light
when a voltage is applied.
<Using the EL Function>
Pressing button
C
causes El internal illumination to
be turned on.
11. All-Reset Procedure
Perform the all-reset procedure described below
after replacing the battery or when the watch does
not run properly or has an abnormal display due to
a strong impact (such as when there is no display
showing or when the alarm sounds continuously).
(1) Press buttons
A ,
B ,
C
and
M
simultaneously.
* All segments in the digital display and the
internal EL illumination will flash during the time
the buttons are pressed.
* All-reset will be activated when any of the
buttons is released. A signal sounds confirming
that the all-reset procedure has been
performed.
(2) Following completion of the all-reset procedure,
reset the calendar and each of the other modes
before using the watch.
12. Precautions
