Citizen IF1-EFX1, Руководство пользователя, Страница: 19 / 62

3. Network Settings and Operation
19
3-6.
Simple Setting Procedure Example for Wired LAN
If you do not know much about network settings, configure the settings about the corresponding
procedure below.
However, the instructions in the procedure may not necessarily be appropriate for your network
environment.
■
Configuration where an IP address is assigned from a DHCP server
1) Connect the LAN cable to the interface board. The LAN cable must be connected to, for example,
an enabled network environment in which a DHCP server exists.
2) The IP address is automatically obtained from the DHCP server within 90 seconds after powering
on the printer and starting up this interface board.
Press the panel button to print out the configuration information and check the assigned IP
address. See 3-3, Printing the Interface Board Configuration (page16) for details.
3) Once the conditions for the printer to join the network are in place, configure the wired LAN
settings in Web Manager.
Connect to Web Manager of the printer from the browser of a PC connected to the same network.
See “4 Web Manager” (page 20) for details.
Instead of Web Manager, you can also use NetToolK, a network configuration tool for Windows.
See “5 NetToolK” (page 30) for details.
■
Configuration using a static IP address
The procedure differs for the part of step 2) above. Since the IP address assigned by the DHCP
server is not used, the ZeroConf function assigns an IP address of 169.254.XX.YY (XX.YY varies
depending on the environment). Press the panel button to print the setting information and then
confirm the assigned IP address.
Adjust the IP address of your PC so that it can connect to the IP address of the printer.
The subsequent procedure is the same as step 3) above.