h
Connector for winder
(CN6):
Connector for connecting Winder (for controlling the motor for auto
paper winding device) (Option)
i
Connector
for
Interface
(CN3):
Either parallel or serial connector is present depending on the board
type.
Connects to each host through a cable. Before connecting the
connector, make sure the host and board are powered off.
3.2. Connector for Power Supply
Connector used: CN1: MOJ-D14 (Iizuka Electric)
Electrical Specifications
Input voltage: 7 to 15 V DC
Current at non printing: 0.15 A average
Current at printing: 0.80 A average (approx. 7.5 A at peak)
The above value is at temperature of 25
°
C and normal humidity.
Average current is the value with print rate of 12.5%.
The values vary with the printing condition, environment of use, operating conditions, etc.
Precautions
1.
Before connecting or disconnecting a connector, make sure the printer power is turned off.
2.
Always use the power voltage within the specified range.
Caution
•
When the power supply other than specified is used, bad effect may occur on printing operation, etc.
When the printer is operated continuously, electronic components in the board may generate heat. Use
the printer paying full attention to heat dissipation.
•
When the power supply with insufficient peak current is used, degradation of print quality may occur
depending on the printing state.
•
Be sure to prepare for easy turning off the power supply in case of power failure.
•
Power supply with various kinds of protective circuits such as overvoltage protection and overcurrent
protection is recommended.
•
If any abnormality such as abnormal odor is sensed during operation, turn the power supply off
quickly.
