Citizen C20502, Руководство пользователя, Страница: 14 / 20

Program the Remote Control
To program the remote control
1.Press and hold the TV, VCR/DVD, SAT/CAB or AUX key for over 2 seconds until the INDlCATOR on
the remote controI turns off. Release the key (the INDICATOR will light again) and the remote controI
enters the PROGRAMMlNG mode.
2.Use the 0 - 9 keys to enter three - digit code number for your equipment. lf the correct code number
is entered, the INDICATOR bIinks three times. If you enter a code not listed beIow, or you press any
other keys than SEARCH and 100 +, the lNDICATOR turns off.
To search codes
1.Press and hoId the TV, VCR/DVD, SAT/CAB or AUX key for over 2 seconds until the INDICATOR
turns off. ReIease the key (the INDICATOR wiII light again) and the remote controI enters the
PROGRAMMING mode.
2.Press the SEARCH key.
3.Press the CH+/- keys to search codes downwards or upwards. Each time you press the CH+/- keys,
the code number decreases or increases by 1 whiIe the remote controI sends the code number for
STANDBY key on your device.
lf the desired code number is found, press the 100 + key to program the code for your device until
the lNDICATOR bIinks three times. Then the remote controI exits from the PROGRAMMING mode
and returns to normal operation. Or press any other key to exit from the PROGRAMMING mode after
the INDICATOR bIinks rapidly eight times, and the operation is not active.
To check the current code number
1.Press and hold the TV, VCR/DVD, SAT/CAB or AUX key for over 2 seconds until the lNDlCATOR
turns off. ReIease the key (the INDlCATOR wiII Iight again) and the remote control enters the
PROGRAMMlNG mode.
2.Press the 100 + key.
3.You may read the code number according to the INDICATOR display status as foIlows.
Notes:
1.If there is no operation within 20 seconds during the steps mentioned above, the remote controI
will automaticalIy exit from the appropriate operation.
2.If only your TV does not respond to the remote control, try 000 for your TV. If the batteries are weak
or exhausted, the remote control can't function,either.
FUNCTIONS & FEATURES (continued)
Instruction Manual
Code Number
LED Display Status
(2 sec. time interval between every two digits.)
First-digit Second-digit Third-digit First-digit Second-digit Third-digit
0 0 0 Blinks rapidly once Blinks rapidly once Blinks rapidly once
1 0 6 Blinks once Blinks rapidly once Blinks six times
0 4 3 Blinks rapidly once Blinks four times Blinks three times
1 5 0 Blinks once Blinks five times Blinks rapidly once
13