3. Others
* Measurement of time rate
The unit(gate) time of measurement must be set at "10s " or integer fold
value of 10s owing to the DFC system, and the measurement must be
performed in the form of complete watch.
* Marking on movement
MIYOTA CO. UNADJUSTED
NO JEWEL JAPAN 6P22
* Typical clearance
Mov't - Caseback
minimum 150 µm or more
Top of hands - Glass
300 - 400 µm *
* depending and subject to the glass and case structure, and hand length
4. Notice Of Casing
The interval between Dial and Glass end should be 150
m to avoid breakage
under drop.
5.Setting Instructions
(1) Setting the date (Quick change function)
Pull the crown out to the first click position and set the date by rotating the crown
backyard.
If the date is set beween 9:00 PM and 0:00 AM, the date will not change correctly.
(2) Setting the normal time
Pull the crown out to the second click position when the second hand reaches the
12 o'clock position so that the second hand stops there.
Then set the hour and minute hands.
When setting the minute hand, put it 4 to 5 minutes earlier than the time to be set,
and then turn it back to the correct time.
Note: The day is changed during the period from about 0:00 AM to about 5:30 AM.
After the time is set, push the crown back simultaneously with the time signal.
The second hand will start running at the same time.
This specifications might be changed without prior notice.
