Cissell MAN383, Руководство пользователя

Страница: 10 / 13

Page 10 Page 10 Page 10 Page 10 Page 10
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
Before operating the conveyor, the conveyor parameters must be entered
into the control and the “current position” set. See “SETTING UP THE
CONVEYOR PARAMETERS” on page 7.
To automatically seek positions on the conveyor, enter the desired posi-
tion on the keyboard (it will show on the upper display). If the entry
is correct, press the ENTER key to enter the position into the memory.
If the entry is incorrect, press CLR and start again. A total of six
positions can be in the memory at one time. These can be entered all at
once or at any other time even while the conveyor is in the precess of
seeking a position. Once a position is brought to the unloading point,
it is automatically removed from the memory. Should incorrect positions
be entered into the memory, SHIFT+CLR will remove ALL positions from the
memory.
The next position that the conveyor will seek is shown in the lower
display. The order that the conveyor places the entered positions into
the memory depends on which option (“pick as entered” or “shortest
route”) was selected. If “pick as entered” was selected, the order of
the positions in the memory will be the same order as they were entered.
If “shortest route” was selected, the control will order the positions
in the memory so that the conveyor will travel the shortest distance
(shortest time) to reach all of the positions in the memory.
To start the seek operation press the NEXT button. When the position is
brought to the unload point the conveyor will stop. Press NEXT to start
the next seek operation.
Pressing the PAUSE button will interrupt the seek operation and stop the
conveyor. The lower display will flash to indicate that the control is
in the pause condition. To restart the seek operation press the NEXT
button.
The conveyor can be operated manually by pressing and holding down one
of the JOG buttons. The conveyor will run only while the button is
depressed. When the button is released, the conveyor will stop. The
JOG buttons are disabled when the conveyor is seeking a position. To go
to manual while the conveyor is seeking a position, press PAUSE. This
will interrupt the seek operation. Now the JOG buttons can be used.
After completing the manual operation, press NEXT to restart the seek
operation.
Pressing the EMERGENCY STOP button at anytime will immediately remove
power from the control and stop the conveyor. Press ON/POWER to reacti-
vate the control.
If “SLO” appears in the display, this indicates that there is a mechani-
cal problem with the conveyor. The control monitors the speed of the
conveyor and stops it if it detects an abnormal speed or if the conveyor
is running in the wrong direction.