Cissell AJ1032, Руководство по эксплуатации и техническому обслуживанию

Страница: 20 / 22

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Maintenance
AJ1032 18
Adjusting Air Line Lubricator Flow Rate
Air system oil lubricator should be adjusted so
approximately one drop of oil every 20 machine cycles
is metered into air system. The following steps outline
the procedure for adjusting air system oil lubricator:
IMPORTANT: To avoid o-ring leaks at top of the
bowl, do NOT remove bowl. Fill through plug.
1. To initially adjust flow rate, turn on air, cycle
press and set screw to obtain desired flow rate.
After system reaches normal operating
temperature, check drip rate again and adjust as
required.
2. To decrease flow rate, turn adjusting screw
clockwise. Likewise, turn counterclockwise to
increase oil flow.
3. Use ISO VG 32 grade oil (refer to Table 3 ). Refer
to Filling Air Line Lubricator for filling
instructions.
Filling Air Line Lubricator
When oil level falls below 1/4 full, refill bowl to
3/4 full (oil level approximately 1/2 inch [12.7 mm]
from top) with ISO VG 32 grade oil. Refer to
Table 3 .
NOTE: Do NOT overfill bowl. Damage to filter,
regulator, valves and cylinders WILL result and
void warranty.
Figure 4
To avoid possible serious injury, ALWAYS
close air supply line shut-off valve AND
lock out air service BEFORE filling oil
bowl.
W348
WARNING
SCR103N
1 Oil Flow Rate Adjusting Screw 5 Air Filter
2 Regulator 6 Oil Fill Hole
3 Air Line Lubricator 7 Downstream Relieving Shut-Off Valve
4 Sight Glass
1631605B
6
3
7
1
5
4
2