51
Appendix A: Troubleshooting
Common Problems and Solutions
Wireless-N Home Router
B
Open a command prompt.
For Windows 98SE and Me:
•
Click
Start
and
Run
. In the
Open
field, type
command
. Press the
Enter
key or click the
OK
button.
For Windows 2000 and XP:
•
Click
Star
t and
Run
. In the
Open
field, type
cmd
. Press the
Enter
key or click the
OK
button. In the
command prompt, type
ping 192.168.1.1
and press the
Enter
key.
•
If you get a reply, the computer is communicating with the Router.
•
If you do NOT get a reply, please check the cable, and make sure Obtain an IP address automatically is
selected in the TCP/IP settings for your Ethernet adapter.
C
In the command prompt, type
ping
followed by your Internet or WAN IP address and press the
Enter
key.
The Internet or WAN IP Address can be found on the Status screen of the Router’s web-based utility. For
example, if your Internet or WAN IP address is 1.2.3.4, you would enter
ping 1.2.3.4
and press the
Enter
key.
•
If you get a reply, the computer is connected to the Router.
•
If you do NOT get a reply, try the ping command from a different computer to verify that your original
computer is not the cause of the problem.
D
In the command prompt, type
ping www.yahoo.com
and press the
Enter
key.
•
If you get a reply, the computer is connected to the Internet. If you cannot open a webpage, try the ping
command from a different computer to verify that your original computer is not the cause of the problem.
•
If you do NOT get a reply, there may be a problem with the connection. Try the ping command from a
different computer to verify that your original computer is not the cause of the problem.
4. I am not getting an IP address on the Internet with my Internet connection.
•
Refer to “Problem #3, I want to test my Internet connection” to verify that you have connectivity.
•
If you need to register the MAC address of your Ethernet adapter with your ISP, please see “Appendix E:
Finding the MAC address and IP Address for Your Ethernet Adapter.” If you need to clone the MAC address
of your Ethernet adapter onto the Router, see the System section of “Chapter 5: Configuring the
Wireless-N Home Router” for details.
•
Make sure you are using the right Internet connection settings. Contact your ISP to see if your Internet
connection type is DHCP, Static IP Address, or PPPoE (commonly used by DSL consumers). Please refer to
the Setup section of “Chapter 5: Configuring the Wireless-N Home Router” for details on Internet
connection settings.
•
Make sure you have the right cable. Check to see if the Internet column has a solidly lit Link/Act LED.
•
Make sure the cable connecting from your cable or DSL modem is connected to the Router’s Internet port.
Verify that the Status page of the Router’s web-based utility shows a valid IP address from your ISP.
•
Turn off the computer, Router, and cable/DSL modem. Wait 30 seconds, and then turn on the Router,
cable/DSL modem, and computer. Check the Status tab of the Router’s web-based utility to see if you get
an IP address.
