background image

3600 Series Routers, and it provides a cost−effective router−DSU/CSU combination with the following
features:

T1 or fractional T1 network interface

• 

N X 64 kbps or N X 56 kbps non−channelized data rates (N = 1 to 24)

• 

Standards−based, including ANSI T1.403 and AT&T Publication 62411

• 

Cables

This card requires an RJ−45 to RJ−45 straight−through cable (provided by customer).

The following table provides the pinouts for T1/E1 trunk and digital voice ports (RJ−48).

Pin

1

Signal

1

RX (input)

2

RX (input)

3

−−

4

TX (output)

5

TX (output)

6

−−

7

−−

8

−−

1

Any pin not referenced on a connector is not connected.

LEDs

The table below provides the specifications for the T1/FT1 LEDs and the loopback button.

LED

Feature

Color

Description

LP

Yellow Line or loopback state is detected or is

manually set by the user.

Off

Normal operation

AL

Red

No receive signal

Yellow

Remote station has an alarm condition.

Blue

The remote station is probably out of
service. If the remote station is an
IOS−based router, its interface may be shut
down.

Off

Normal operation

CD

Green

The internal DSU/CSU in the WAN
interface card is communicating with

Cisco − WIC−1DSU−T1 WAN Interface Card Cable Specifications

Содержание WAN Interface Card Cable WIC-1DSU-T1

Страница 1: ...Cable Specifications 1 Document ID 46795 1 Introduction 1 Prerequisites 1 Requirements 1 Components Used 1 Conventions 1 WIC 1DSU T1 WAN Interface Card 1 Cables 2 LEDs 2 Related Information 3 Cisco WIC 1DSU T1 WAN Interface Card Cable Specifications i ...

Страница 2: ...e versions The information in this document was created from the devices in a specific lab environment All of the devices used in this document started with a cleared default configuration If your network is live make sure that you understand the potential impact of any command Conventions For more information on document conventions see the Cisco Technical Tips Conventions WIC 1DSU T1 WAN Interfa...

Страница 3: ... 2 RX input 3 4 TX output 5 TX output 6 7 8 1 Any pin not referenced on a connector is not connected LEDs The table below provides the specifications for the T1 FT1 LEDs and the loopback button LED Feature Color Description LP Yellow Line or loopback state is detected or is manually set by the user Off Normal operation AL Red No receive signal Yellow Remote station has an alarm condition Blue The ...

Страница 4: ...to test the connection from your site to the central office switch Push this button again to turn loopback mode off Related Information Technical Support Cisco Systems All contents are Copyright 1992 2005 Cisco Systems Inc All rights reserved Important Notices and Privacy Statement Updated Jun 26 2005 Document ID 46795 Cisco WIC 1DSU T1 WAN Interface Card Cable Specifications ...

Отзывы: