1
Power
Green = Power is on
Off = Power is disconnected from its power source
2
WPS
WPS
WPS
button
3
Paired
Blinking Orange = WPS button has been pushed and pairing is in
progress
Solid Green = At least one wireless receiver has been paired
Flashing
Green
= At least one wireless receiver is paired and
wireless activity is detected
Off = No wireless association
4
Link
Solid Green = Ethernet link is detected
Blinking Green = Ethernet link is detected and wired activity is
present
Off = Ethernet link is not detected
Front Panel
Installing Your Wireless Access Point and Wireless Receiver
Follow the instructions below to install your Wireless Access Point and Wireless Receiver.
1. Before you connect the Access Point, ensure the Gateway is powered on. Connect one VEN501 unit to
your Residential Gateway using the provided yellow Ethernet cable.
Note
: This illustration may vary from the actual product.
Rear Panel
Note
: This illustration may vary from the actual product.
2. Connect the power adapter to the Access Point and plug it into a wall outlet. You will see the unit’s
Power and Ethernet LEDs go on.
3. Connect the cord from the DC Power Adapter to the POWER connector on the rear of the Receiver, and
plug the adapter into an AC wall outlet, and then connect the Receiver to your TV. (For more details on
connecting your Receiver to your TV, refer to your TV user manual.)
4. When power is applied to the Receiver; the Power button lights green. Ensure that your TV is
powered on.
5. Once the Receiver powers on, wait until a prompt appears on your TV screen asking if you wish to
connect.
6. On the front panel of the Receiver, press and release the OK button. Go to the Access Point and press
and hold the WPS button for two seconds then release to activate the WPS process. The WPS LED will
blink orange.
7. An icon appears on the TV screen, indicating that the connection sequence is in process. When three
horizontal dots appear, the connection has been successful. On the front panel of the Receiver, two or
more LEDs on the Signal Strength indicator will light green. You have now established a secure wireless
connection between the Access Point and the Receiver and can begin enjoying U-verse service.
Installing Additional Wireless Receivers
To connect additional Wireless Receivers repeat steps 3-7 above.
Installation
The VEN501 enables you to transmit multiple standard- and high-defi nition video streams throughout your
home wirelessly. You can enjoy a full range of video services and applications without having to run wires, lay
cables, or drill holes.
The U-verse Wireless Access Point operates only with authorized U-verse Wireless Receiver(s).
POWER
PAIRED
LINK
VEN501
WPS
T15919
1
2
3
4
Reset
Ethernet
12VDC
T15920
1
2
3
1
Reset
Reset Button
Resets the VEN501 to its default settings
2
Ethernet
Ethernet Port
Connects to the Ethernet-equipped U-verse Residential
Gateway
3
12VDC
Power Connector
T16075
VEN501
Residential Gateway
POWER
PAIRED
LINK
VEN501
WPS
POWER
LINK
HD
REC
OK
MENU
ISB7105
U-verse Wireless Receiver
