InstallatIon GuIde
Cisco SPA122 ATA
3
Using your Cisco ATA as a Router
These instructions are only for use when you have no separate router, wireless router, or combination broadband
modem/router already in your network. This is for advanced users only.
If you do not have a router, you can connect your broadband modem directly into your Cisco ATA and then configure it to act as a router. Please
follow the instructions below to configure it:
Configure Cisco ATA as a Router
1. Determine the IP address of your Cisco ATA.
a. Plug in an analog phone to the
Phone 1
or
Phone 2
port.
b. Dial
****
and you will hear the Cisco Configuration Menu.
c. Dial
110#
to obtain the IP address of your Cisco ATA.
2. Access the Cisco ATA web interface to your Cisco ATA.
a. Open a browser window on your PC or laptop.
b. Enter the IP address into your browser. Your default
Username
is “cisco” and your default
Password
is “cisco”.
c. This should open up the configuration window. If you can’t access the configuration window:
• Recheck your IP address
• If you have difficulty, plug your PC or laptop directly into the Ethernet port of the ATA and type in the IP address.
• If you still have difficulty, go back to the IVR and dial
**** from the phone connected to your ATA,
then dial
7932#
and then
dial
1
to turn on the web interface.
