3-5
PA-A2 ATM CES Port Adapter Installation and Configuration
OL-346-01
Chapter 3 Removing and Installing the PA-A2 ATM CES Port Adatper
Port Adapter Slot Divider
Cisco uBR7200 Series Routers—Removing the Slot Divider
If you are installing a dual-width module in a Cisco uBR7200 router that has two single-width modules
installed, you must first remove the slot divider that is located between the two slots. Follow this
procedure:
Step 1
Remove installed single-width port adapters from the slots on both sides of the port adapter slot divider.
Step 2
With one hand, raise the slot divider lever to unlock the slot divider from the chassis.
(See
Figure 3-2
.)
Figure 3-2
Slot Divider Lever—Cisco uBR7246 Shown
Step 3
With the slot divider lever still raised, use your other hand to pull the slot divider from the chassis.
(See
Figure 3-3
.)
Figure 3-3
Removing the Slot Divider from the Chassis—Cisco uBR7246 Shown
Step 4
Store the slot divider in a location where you can retrieve it for use later.
14297
Slot divider lever
14330
