5-28
PA-8T-232 Synchronous Serial Port Adapter Installation and Configuration
OL-3562-03
Chapter 5 Configuring the PA-8T-232 Interfaces
Checking the Configuration
Using the show interfaces Command
The show interfaces command displays status information (including the physical slot and interface
address) for the interfaces you specify. All of the examples that follow specify serial interfaces.
For complete descriptions of interface subcommands and the configuration options available for
Catalyst RSM/VIP2, Cisco 7100 series, Cisco 7200 series, Cisco uBR7200 series, Cisco 7301 routers,
Cisco 7401ASR router, and VIP interfaces, refer to the publications listed in the
Documentation” section on page viii
. This section provides output examples for some of the supported
platforms.
Note
The outputs that appear in this document may not match the output you receive when running these
commands. The outputs in this document are examples only.
Catalyst RSM/VIP2 in Catalyst 5000 Family Switches
Following is an example of the show interfaces command, which displays status information (including
the physical slot and interface address) for the interfaces you specify. In these examples, the eight serial
interfaces (0 to 7) are on a port adapter in port adapter slot 1 of a Catalyst RSM/VIP2; also, most of the
status information for each interface is omitted. (Interfaces are administratively shut down until you
enable them.)
Router# show interfaces serial 1/0
Serial1/0 is up, line protocol is up
Hardware is cyBus Serial
Internet address is 10.0.0.0
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation HDLC, loopback not set, keepalive not set
(Additional display text omitted from this example]
Router# show interfaces serial 1/1
Serial1/1 is up, line protocol is up
Hardware is cyBus Serial
Internet address is 10.0.0.1
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation HDLC, loopback not set, keepalive not set
(Additional display text omitted from this example]
Router# show interfaces serial 1/2
Serial1/2 is up, line protocol is up
Hardware is cyBus Serial
Internet address is 10.0.0.2
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation HDLC, loopback not set, keepalive not set
(Additional display text omitted from this example]
Router# show interfaces serial 1/3
Serial1/3 is up, line protocol is up
Hardware is cyBus Serial
Internet address is 10.0.0.3
MTU 1500 bytes, BW 1544 Kbit, DLY 20000 usec, rely 255/255, load 1/255
Encapsulation HDLC, loopback not set, keepalive not set
(Additional display text omitted from this example]
