7-3
Optical Services Modules Installation and Configuration Note, 12.2SR
OL-9465-03
Chapter 7 Configuring the Channelized 12-port CT3/T1 Optical Services Modules
Supported Features
General Features
The general features are as follows:
•
Channelized DS3 with 28 DS1 lines or 21 E1 lines multiplexed into a DS3 line.
•
C-bit parity, M23, and auto-detect framing.
•
Internal clocking configurable.
•
Bit error rate test (BERT) diagnostics for each DS-3 channel
•
Local, line, and remote loopback.
•
Generation and termination of DS-3 maintenance data link (MDL) in C-bit framing.
•
Compliance with ANSI T1.231-1993, Bellcore GR820, ANSI T1.107, ANSI T1.403 1989, G.703
Section 2, G.704 Section 3, AT&T Pub. 62411 1990, and Facilities Data Link (ANSI T1.403 and
AT&T 54016).
Serial Encapsulation Protocols
The OSMs support for the following serial encapsulation protocols:
•
Point-to-Point Protocol (PPP)
•
Distributed Multilink PPP (dMLPPP)
The OSM-12CT3/T1 module supports dMLPPP, which means that the MLPPP encapsulation is
performed on the OSM-12CT3/T1 module rather than the route processor. The following dMLPP
features are supported:
–
336 bundles per module
–
A maximum of 12 DS1/E1 channels per bundle
–
All links in a bundle should operate at the same speed
–
100 ms of differential delay
•
High-Level Data Link Control (HDLC)
•
Frame Relay
Configure the OSM-12CT3/T1 interfaces for Frame Relay as described in the
Cisco IOS Wide-Area
Networking Configuration Guide, Release 12.1
under “Configuring Frame Relay” and in the
Cisco
IOS Wide-Area Networking Command Reference, Release 12.1
at:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/wan_c/wcdfrely.htm
http://www.cisco.com/univercd/cc/td/doc/product/software/ios121/121cgcr/wan_r/wrdfrely.htm
Configure traffic shaping for Frame Relay as described in the
Cisco IOS Quality of Service
Solutions Configuration Guide
under “Configuring Distributed Traffic Shaping” at:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fqos_c/fqcprt4/qcfdts.h
tm.
For information on Multilink Frame Relay (FRF.16), see
•Multilink Frame Relay (FRF.16),
page 1-4
.
•
MPLS/VPN
For MPLS/VPN configuration information, see
Chapter 9, “Configuring Multiprotocol Label
Switching on the Optical Services Modules.”