1-37
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
78-19416-01
Chapter 1 Install the Cisco ONS 15310-MA SDH
Required Tools and Equipment
NTP-H190 Install the Rear Cover
Caution
Always use the supplied ESD wristband when working with a powered ONS 15310-MA SDH. For
detailed instructions on how to wear the ESD wristband, refer to the
Cisco ONS Electrostatic Discharge
.
Note
Connect all cables on the backplane before installing the rear cover.
Step 1
Using a #2 Phillips screw driver, remove the six panhead screws from the Electrical Interface Assemblies
(EIAs) located on the A-side and B-side of the backplane (
).
Purpose
This procedure explains how to install the rear cover on an ONS 15310-MA
SDH shelf.
Tools/Equipment
•
#2 Phillips screwdriver
•
1/4-inch nut driver
•
Six 1/4-inch hexagonal standoffs 6-32 x 3.3.25
Prerequisite Procedures
NTP-H158 Install the Electrical Cables, page 1-27
NTP-H160 Install Optical Cables, page 1-29
Required/As Needed
Required
Onsite/Remote
Onsite
Security Level
None
Содержание ONS 15310-MA SDH
Страница 20: ...Figures xx Cisco ONS 15310 MA SDH Procedure Guide Release 9 1 and Release 9 2 78 19416 01 ...
Страница 45: ...xlv Cisco ONS 15310 MA SDH Procedure Guide Release 9 1 and Release 9 2 78 19416 01 Preface ...
Страница 48: ...xlviii Cisco ONS 15310 MA SDH Procedure Guide Release 9 1 and Release 9 2 78 19416 01 Preface ...
Страница 290: ...15 4 Cisco ONS 15310 MA SDH Procedure Guide Release 9 1 and Release 9 2 78 19416 01 Chapter 15 Power Down the Node ...