Cisco ONS 15310-MA SDH, Руководство по процедурам

Страница: 279 / 632

14-15
Cisco ONS 15310-MA SDH Procedure Guide, Release 9.1 and Release 9.2
78-19416-01
Chapter 14 Maintain the Node
Before You Begin
NTP-H115 Switch the Node Timing Reference
Step 1
Complete the “DLP-H29 Log into CTC” task on page 16-43 at the node that you want to monitor. If you
are already logged in, continue with Step 2.
Step 2
As needed, use the following tasks to change the display of node timing maintenance information:
•
DLP-H177 Manual or Force Switch the Node Timing Reference, page 17-68
• DLP-H178 Clear a Manual or Force Switched Node Timing Reference, page 17-68
Stop. You have completed this procedure.
NTP-H116 View the Timing Report
Step 1
Complete the “DLP-H29 Log into CTC” task on page 16-43 at the node where you want to view the node
timing status. If you are already logged in, continue with Step 2 .
Step 2 Click the Maintenance > Timing > Report tabs.
Step 3
In the Timing Report area you can view node timing information. The date and time of the report appear
at the top of the report. The time stamp is the same as the alarms time stamp and can be configured using
the
“DLP-H75 Display Alarms and Conditions Using Time Zone” task on page 16-93 . Table 14-2
describes the report fields and entries.
Step 4 To update the report, click Refresh .
Purpose This procedure switches the node timing reference to enable
maintenance on a timing reference or to return the node timing to normal
operation.
Tools/Equipment None
Prerequisite Procedures NTP-H23 Set Up Timing, page 3-10
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Maintenance or higher
Purpose This procedure displays the current status of the ONS 15310-MA SDH
timing references.
Tools/Equipment None
Prerequisite Procedures NTP-H23 Set Up Timing, page 3-10
Required/As Needed As needed
Onsite/Remote Onsite or remote
Security Level Retrieve or higher