c) Repeat Step 3 to attach the other slider rail to the other side of the rack.
To make sure that the slider rails are at the same level, you should use a level tool, tape measure, or carefully count
the screw holes in the vertical mounting rails.
Step 4
Insert the switch into the rack and attach it as follows:
a) Holding the switch with both hands, position the two rear rack-mount brackets on the switch between the rack or
cabinet posts that do not have slider rails attached to them (see the following figure).
b) Align the two rear rack-mount guides on either side of the switch with the slider rails installed in the rack. Slide the
rack-mount guides onto the slider rails, and then gently slide the switch all the way into the rack until the front
rack-mount brackets come in contact with two rack or cabinet posts.
If you attached a grounding cable to the chassis, you will need to bend one of the rack-mount rails slightly
to allow the grounding lug to go behind the rail.
Note
Cisco Nexus 93180LC-EX NX-OS Mode Hardware Installation Guide
19
Installing the Switch Chassis
Installing the Switch Using the NXK-ACC-KIT-1RU Rack-Mount Kit
Содержание Nexus 93180LC-EX
Страница 6: ...Cisco Nexus 93180LC EX NX OS Mode Hardware Installation Guide vi Contents ...
Страница 14: ...Cisco Nexus 93180LC EX NX OS Mode Hardware Installation Guide 4 Overview Overview ...
Страница 22: ...Cisco Nexus 93180LC EX NX OS Mode Hardware Installation Guide 12 Preparing the Site Clearance Requirements ...
Страница 66: ...Cisco Nexus 93180LC EX NX OS Mode Hardware Installation Guide 56 LEDs LEDs ...