Adding the NSS to your Network
Configuring the Network Ports
Cisco Small Business NSS3000 Series Network Storage System Administration Guide
34
3
•
Open
: If the cable has an open, the message appears as "pair a-b open@
Xm (where "a" and "b" are the numbers of the pair, "X" is the location in the
cable where the open was found, and "m" stands for meters).
•
Disconnected
: If the cable shows an open at the minimum measurable
distance, it is assumed that the cable is not connected. The message "Cable
is not connected" appears.
The cable diagnostic test only runs the first time you display the
Cable
Diagnostics
screen. To rerun the test, scroll through the LCD pages until you
redisplay the
Cable Diagnostics
screen.
Configuring the Network Ports
By default the NSS runs network services on their well known (IETF defined) port
numbers. You can change the port on which any particular service runs. When you
disable WAN access for a given service, only hosts on the same subnet as the
NSS may connect to that service. This is a shortcut to manually defining an
equivalent network filter.
To set up the network services:
STEP 1
From the
Manager Menu
, click
Network
Ports
.
