Figure 29: Cisco NCS 4216 Flash Token Memory Stick
Removing a USB Flash Device
To remove and then replace a USB flash token memory stick from a Cisco NCS 4216, follow these steps:
Procedure
Step 1
Pull the memory stick from the USB port.
Step 2
To replace a Cisco USB Flash memory stick, simply insert the module into the USB port labeled MEM as
shown in the
Cisco NCS 4216 Flash Token Memory Stick
figure. The Flash memory module can be inserted
in only one way, and can be inserted or removed regardless of whether the router is powered up or not.
You can insert or remove the memory stick whether the router is powered on or not.
Note
This completes the USB Flash memory installation procedure.
Connecting Timing Cables
The sections describe how to connect timing cables to the Cisco NCS 4216:
When installing the cabling to the RSPs, we recommend that you leave a service loop of extra cabling sufficient
to allow for fan tray removal.
Note
Connecting Cables to the BITS Interface
The following steps describe how to connect a cable to the router BITS port:
Procedure
Step 1
Confirm that the router is powered off.
Step 2
Connect one end of the cable to the BITS port using a straight-through, shielded RJ48C-to-RJ48C cable.
Installing the Cisco NCS 4216
51
Installing the Cisco NCS 4216
Removing a USB Flash Device
