Cisco N9K-C9396TX, Руководство по установке оборудования

Страница: 39 / 74

C H A P T E R
4
Connecting the Switch to the Network
• Setting Up the Management Interface, on page 29
• Uplink Connections, on page 29
• Downlink Connections, on page 30
• Guidelines for Connecting Ports, on page 30
• Maintaining Transceivers and Optical Cables, on page 32
Setting Up the Management Interface
The management port (MGMT ETH) provides out-of-band management, which enables you to use the
command-line interface (CLI) to manage the switch by its IP address. This port uses a 10/100/1000 Ethernet
connection with an RJ-45 interface.
Before you begin
The switch must be powered on.
Step 1 Connect the RJ-45, UTP cable to the MGMT ETH port on the switch.
Step 2
Connect the other end of the cable to a 10/100/1000 Ethernet port on a network device.
What to do next
You are ready to connect the interface ports on each of the line cards to the network.
Uplink Connections
The switch has an uplink module with 12 or six 40-Gigabit optical ports or four 100-Gigabit optical ports.
For a list of transceivers and cables used by this switch for uplink connections, see
http://www.cisco.com/c/en/us/support/interfaces-modules/transceiver-modules/products-device-support-tables-list.html .
By default, the 40-Gigabit uplink ports operate at 40 Gbps, but you can use the speed-group 10000 command
to change the administrative speed to 10 Gbps. If you change the speed, you must also use a QSFP-to-SFP
adapter and a supported SFP+ transceiver in each of the converted SFP+ ports. All of the ports in a group of
Cisco Nexus 9396TX NX-OS Mode Switch Hardware Installation Guide
29