3-41
Cisco MGX 8950 Hardware Installation Guide
Release 3, Part Number 78-14147-02 Rev. A0, November 2002
Chapter 3 Installing a Cisco MGX 8950
Installation Procedures
Step 3
Route the cable outside the cable management brackets, then insert the other end of the cable labeled
“PEM 1 J1” into the primary (bottom) PEM receptacle labelled “J1.”
Push the connector in to seat it
Step 4
Tighten the captive screws firmly by hand.
Step 5
Insert the connector labeled “Card Cage B1” into the card cage receptacle labeled “PSB 1.”
Push the connector in to seat it.
Step 6
Tighten the captive screws firmly by hand.
Step 7
Insert the other end of the cable labeled “PEM 2 J1” into the secondary (top) PEM receptacle labeled
“J1.”
Step 8
Tighten the captive screws firmly by hand.
Step 9
Insert the connector labeled “Card Cage B2” into the card cage receptacle labeled “PSB 2.”
Push the connector in to seat it.
Step 10
Tighten the captive screws firmly by hand.
Step 11
Insert the other end of the cable labeled “PEM 2 J2” into the secondary (top) PEM receptacle labeled
“J2.”
Push the connector in to seat it.
Step 12
Tighten the captive screws firmly by hand.
Step 13
Insert the connector labeled “Card Cage A2” into the card cage receptacle labeled “PSA 2.”
Push the connector in to seat it.
Step 14
Tighten the captive screws firmly by hand.
Step 15
Route cable outside the cable management system brackets, then insert the other end of the cable labeled
“PEM 1 J2” into the primary (lower) PEM receptacle labeled “J2.”