C-3
Cisco ME 3400E Ethernet Access Switch Hardware Installation Guide
OL-16447-01
Appendix C Configuring the Switch with the CLI-Based Setup Program
Entering the Initial Configuration Information
Step 3
Enter an enable secret password, and press
Return
.
The password can be from 1 to 25 alphanumeric characters, can start with a number, is case sensitive,
allows spaces, but ignores leading spaces. The secret password is encrypted and the enable password is
in plain text.
Enter enable secret:
secret_password
Step 4
Enter an enable password, and press
Return
.
Enter enable password:
enable_password
Step 5
Enter a virtual terminal (Telnet) password, and press
Return
.
The password can be from 1 to 25 alphanumeric characters, is case sensitive, allows spaces, but ignores
leading spaces.
Enter virtual terminal password:
terminal-password
Step 6
(Optional) Configure Simple Network Management Protocol (SNMP) by responding to the prompts.
You can also configure SNMP later through the CLI. To configure SNMP later, enter
no
.
Configure SNMP Network Management? [no]:
no
Step 7
Enter the interface name (physical interface or VLAN name) of the interface that connects to the
management network, and press
Return
. For this release, always use vlan1 as that interface.
Enter interface name used to connect to the
management network from the above interface summary:
vlan1
Step 8
Configure the interface by entering the switch IP address and subnet mask and pressing
Return
. The IP
address and subnet masks shown below are examples.
Configuring interface vlan1:
Configure IP on this interface? [yes]:
yes
IP address for this interface:
10.4.120.106
Subnet mask for this interface [255.0.0.0]:
255.0.0.0
Step 9
Enter
Y
to configure the switch as the cluster command switch. Enter
N
to configure it as a member
switch or as a standalone switch.
If you enter
N
, you can configure the switch as a command switch later through the CLI. To configure
it later, enter
no
.
Would you like to enable as a cluster command switch? [yes/no]:
no
You have now completed the initial configuration of the switch, and the switch displays its initial
configuration. This is an example of output that appears:
The following configuration command script was created:
hostname switch1
enable secret 5 $1$Ulq8$DlA/OiaEbl90WcBPd9cOn1
enable password
enable_password
line vty 0 15
password
terminal-password
no snmp-server
!
no ip routing
!
interface Vlan1
no shutdown
ip address 10.4.120.106 255.0.0.0
!
interface FastEthernet1/0/1
