![background image](http://html.mh-extra.com/html/cisco/linksys-wag325n/linksys-wag325n_user-manual_64959025.webp)
19
Chapter 5: Configuring the Wireless-N ADSL2+ Gateway
The Setup Tab
Wireless-N ADSL2+ Gateway
The Advanced Routing Tab
The
Advanced Routing
screen allows you to configure the NAT, dynamic routing, and static routing settings.
Advanced Routing
•
Operating Mode. In this section, you will configure the Gateway’s general routing settings.
•
NAT. NAT is a security feature that is enabled by default. It enables the Gateway to translate IP addresses
of your local area network to a different IP address for the Internet. To disable NAT, click the
Disabled
radio button.
•
Dynamic Routing. With Dynamic Routing you can enable the Gateway to automatically adjust to physical
changes in the network’s layout. Using RIP, the Gateway determines the network packets’ route based on the
fewest number of hops between the source and the destination. The RIP protocol regularly broadcasts routing
information to other Gateways on the network.
•
RIP. If you have multiple routers, you may want to use the Routing Information Protocol (RIP) so the routers
can exchange routing information with each other. To use RIP, select the
Enabled
radio button. Otherwise,
keep the default,
Disabled
.
•
RIP Version. Select the protocol version you want,
RIP1
or
RIPv2
.
•
Static Routing. If the Gateway is connected to more than one network, it may be necessary to set up a static
route between them. A static route is a pre-determined pathway that network information must travel to
reach a specific host or network. To create a static route, change the following settings:
•
Select set number. Select the number of the static route from the drop-down menu. The Gateway
supports up to 20 static route entries. If you need to delete a route, then select the entry and click the
Delete This Entry
button.
•
Destination IP Address. The Destination IP Address is the address of the remote network or host to which
you want to assign a static route. Enter the IP address of the host for which you wish to create a static
route. If you are building a route to an entire network, be sure that the network portion of the IP address is
set to 0.
•
Subnet Mask. Enter the Subnet Mask (also known as the Network Mask), which determines which portion
of an IP address is the network portion, and which portion is the host portion.
•
Gateway. Enter the IP address of the gateway device that allows for contact between the Gateway and the
remote network or host.
Figure 5-11: Advanced Routing