Cisco ISB7105, Руководство по эксплуатации продукта

Страница: 29 / 32

29
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one of the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit diff erent from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifi cations not expressly approved by the party responsible for
compliance could void the user’s authority to operate this equipment.
For operation within the 5150-5250 MHz and 5470-5725 MHz frequency ranges, it is restricted to
indoor environment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
IMPORTANT NOTE:
FCC RF Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance 20cm
between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
The availability of some specifi c channels and/or operational frequency bands are country
dependent and are fi rmware programmed at the factory to match the intended destination. The
fi rmware setting is not accessible by the end user.
ISB7105
with PCB antenna and max. antenna gain is 4.8 dBi in 5G.
Industry Canada Statement:
This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation.
Caution:
The device for the bands 5150-5250 MHz and 5470-5725 MHz is only for indoor usage to reduce
potential for harmful interference to co-channel mobile satellite systems.
The maximum antenna gain permitted (for devices in the band 5250-5725 MHz (
5
dBi)) to comply
with the e.i.r.p. limit; and
The maximum antenna gain permitted (for devices in the band 5725-5825 MHz (
5
dBi)) to comply
with the e.i.r.p. limits specifi ed for point-to-point and non point-to-point operation as appropriate,
as stated in section A9.2(3).
High power radars are allocated as primary users (meaning they have priority) of 5250-5350 MHz
and 5650-5850 MHz and these radars could cause interference and/or damage to LE-LAN devices.