3-50 Cisco IGX 8400 Series Installation and Configuration
IGX Configuration Summary
— Set up any subrate trunk interface control templates if desired (cnftrkict).
•
For setting up voice lines:
— Activate the line (upcln or upln).
— Configure the line (cnfln). If you use cnfln to configure the line for voice SVC caching in
conjunction with VNS, see to the VNS documentation for a description of this service and
the CVM or UVM description in the Cisco IGX 8400 Series Reference for line-information.
— Configure redundancy (addyred).
•
For setting up data lines and ports:
— Activate the line (upcln).
— Configure the line (cnfcln).
— Configure redundancy (addyred).
•
Set up Frame Relay lines and ports. (See the section “Setting Up Frame Relay Ports and
Connections (UFM)” or “Setting Up Frame Relay Ports and Connections (FRM)” for a
description.)
— Activate each port (upfrport).
— Specify a mode for the card as needed if the card is a UFM-U (cnfmode). To determine the
current mode of a particular UFM-U, use dspmode.
•
For setting up ATM lines and ports:
— Activate the line (upln).
— Configure the line (cnfln).
— Activate the ports (upport).
— Configure the ports (cnfport)
— For a UXM-E, specify cellbus bandwidth as needed (cnfbusbw—a superuser command).
•
For setting up voice connections:
— Add the connections (addcon).
— Configure connection parameters (cnfvchadv, cnfchdl, cnfchec, cnfchgn, cnfcond,
cnfcondsc, cnfrcvsig, cnfsmtsig, cnfvchtp, cnfchutl)
— For only the UVM, additional configuration commands you can use are: (cnfuvmchparm,
cnfchfax, cnflnpass. (Use dsplncnf to check whether the port is configured for External,
Pass-through, Blocking, or Inserting.)
