Cisco IAD2801 Series, Руководство по установке

Страница: 42 / 79

4-2
Cisco IAD2801 Series Integrated Access Devices Hardware Installation Guide
OL-12433-01
Chapter 4 Chassis Installation Procedures
Setting Up the Chassis
Rack-Mounting the Chassis
If you are planning to rack-mount the router, do so before making network and power connections.
Internal modules should be installed prior to rack-mounting.
Cisco IAD2801 series integrated access devices can be installed only in 19-inch racks, and cannot be
center mounted. Use the standard brackets shipped with the router for mounting the chassis in a 19-inch
rack.
Note
Brackets for 23-inch (58.42-cm) equipment racks are not available for the Cisco IAD2801.
You can mount the router in the following ways:
• Front mounting—Brackets attached at the front of the chassis with the front panel facing forward.
•
Rear mounting—Brackets attached at the rear of the chassis with the rear panel facing forward.
The brackets are shown in Figure 4-1 .
Figure 4-1 Rack-Mounting Brackets for the Cisco IAD2801 for a 19-Inch Rack
Attaching Rack-Mount Brackets to Cisco IAD2801 Series Integrated Access Devices
Use four of the supplied number-8 Phillips flat-head screws to attach the long side of each bracket to the
router.
Figure 4-2 shows how to attach the brackets to the sides of the router with the front panel forward.
Figure 4-2 Attaching Rack-Mounting Brackets to a Cisco IAD2801
95769
95770
R