Cisco FM3500 Endo, Руководство по установке и настройке

Страница: 32 / 178

Hardware installation
© 2021 Cisco and/or its affiliates. All rights reserved. Page 32 of 177
To do a 'hard' (device firmware) reboot under emergency conditions (for
example, if the unit malfunctions), do the steps in the following sub- section.
Device firmware reboot
1. Remove the bottom cover from the main unit enclosure as shown
in
“Connecting LAN cables to the unit” (page 36)
.
2. Insert a long tool with a thin shaft, such as a paper clip or a thin
screwdriver, into the RESET button port until the tool touches the
bottom ( Figure 8 (page 32) ).
Figure 8. Cisco FM3500 Endo (Hardware RESET button port)
3. Press the RESET button for one second, then release the button
immediately.
• The unit will reboot.
Resetting the unit to factory settings
The following methods are available to do a factory reset:
1. To do the reset using the offline Configurator interface, refer to
“Resetting the unit to factory defaults” (page 138)
.
2. To do the reset using FM Racer, refer to the Fluidmesh Networks
FM Racer User Manual .
3. To do the reset by physically accessing the unit, follow the
procedure below.
To reset the radio to its factory default settings, do the steps that follow:
CAUTION
Do not do a factory reset unless the unit needs to be
reconfigured using its factory configuration as a starting point.
A factory reset will reset the unit's IP address and administrator
password, and will disconnect the unit from the network.