IMPORTANT
By default, Ethernet speeds are set to Auto. It is strongly
recommended that you do not change the Ethernet speed
settings unless errors and/or unwanted behaviors are detected
on the Ethernet connection.
To change the ethernet speed settings, click the
-ethernet settings
link
under
ADVANCED SETTINGS
in the left-hand settings menu.
• The
Ethernet Settings
dialog will be shown (
Figure 35. Configurator GUI (Ethernet settings window)
To change the ethernet settings, do the following steps:
•
To choose the correct data exchange speed for each Ethernet
port, click one of the following data exchange speeds:
•
Auto
(The data exchange speed for the selected port will
be chosen automatically).
•
10 Mbit half duplex
.
•
10 Mbit full duplex
.
•
100 Mbit half duplex
.
•
100 Mbit full duplex
.
6.6.3. Static routes
The Static routes window is used to set static routing rules (in other
words, manually-configured routing entries, as opposed to routing
instructions from a dynamic routing table) for a Cisco unit.
Static routes are typically used if there is a need to do any of the following
in context of the network:
• Access a remote subnet that does not belong to a local network•
Access other Cisco radio units or client devices across the
local network
• Reach gateways (such as Internet gateways)
• Create networks that include 'fixed' devices (such as CCTV
cameras)
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved.
Page 93 of 176
