Cisco FM PONTE-50, Руководство по установке и настройке

Страница: 98 / 132

Rebooting the unit
The reboot window contains controls that allow you to reboot the Cisco
FM Ponte kit (in other words, to re-start the unit's operating system).
To reboot the unit, do the following steps:
1. Click the -reboot link under MANAGEMENT SETTINGS in the
left-hand settings menu.
• The unit reboot dialog will be shown ( Figure 47 (page
98) ).
Figure 47. Configurator GUI (unit reboot dialog)
2. Reboot the unit by clicking the YES link. Alternatively, abort the
reboot by clicking the NO link.
• If the YES link was clicked, the unit will reboot.
7.7.8. Logging out
If clicked, the logout option logs the current user off the unit, and out of the
Configurator interface.
• To log out, click the -logout link under MANAGEMENT
SETTINGS in the left-hand settings menu.
• You will be logged off the unit and out of the Configurator
interface with no further prompting.
• The web browser will show the Authentication Required
dialog ( Figure 48 (page 98) ). If needed, use the dialog to
log in again.
Figure 48. Web browser (Authentication Required
dialog)
Device configuration using the configurator interface
© 2021 Cisco and/or its affiliates. All rights reserved. Page 98 of 132