
Quality of Service
Configuring QoS - General
Cisco 500 Series Stackable Managed Switch Administration Guide Release 1.3
480
25
Setting QoS Properties
To select the QoS mode:
STEP 1
Click
Quality of Service
>
General
>
QoS Properties
.
STEP 2
Set the QoS mode. The following options are available:
•
Disable
—QoS is disabled on the device.
•
Basic
—QoS is enabled on the device in Basic mode.
•
Advanced
—QoS is enabled on the device in Advanced mode.
STEP 3
Select
Port/LAG
and click GO
to display/modify all ports/LAGs on the device and
their CoS information.
The following fields are displayed for all ports/LAGs:
•
Interface
—Type of interface.
•
Default CoS
—Default VPT value for incoming packets that do not have a
VLAN Tag. The default CoS is 0. The default is only relevant for untagged
frames and only if the system is in Basic mode and Trust CoS is selected in
the Global Settings page.
Select
Restore Defaults
to restore the factory CoS default setting for this
interface.
STEP 4
Click
Apply
. The Running Configuration file is updated.
To set QoS on an interface, select it, and click
Edit
.
STEP 1
Enter the parameters.
•
Interface
—Select the port or LAG.
•
Default CoS
—Select the default CoS (Class-of-Service) value to be
assigned for incoming packets (that do not have a VLAN tag).
STEP 2
Click
Apply
. The interface default CoS value is saved to Running Configuration file.
Содержание ESW2-550X-48
Страница 1: ...Cisco ESW2 Series Advanced Switches ADMINISTRATION GUIDE ...
Страница 221: ...Smartport Built in Smartport Macros 203 Cisco 500 Series Stackable Managed Switch Administration Guide Release 1 3 11 ...
Страница 493: ...Access Control Defining ACL Binding 475 Cisco 500 Series Stackable Managed Switch Administration Guide Release 1 3 24 ...
Страница 547: ...SNMP SNMP Notification Filters 529 Cisco 500 Series Stackable Managed Switch Administration Guide Release 1 3 26 ...