Purpose
Command or Action
Tools and Equipment Required for Installation,
on page 25
Gather the required tools and equipment.
Step 3
—
Remove the blank faceplates from the NIM slot
that you want to use.
Step 4
Installing the NIM E-Series NCE into the
Router, on page 57
Install the NIM E-Series NCE into the router.
Step 5
Verifying NIM E-Series NCE Installation, on
page 59
Verify the NIM E-Series NCE installation.
Step 6
Installing the NIM E-Series NCE into the Router
The NIM E-Series NCE can be installed either before or after mounting the router, whichever is convenient.
Only trained and qualified personnel should be allowed to install, replace, or service this equipment. Statement
1030
Danger
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network voltage
(TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some LAN and
WAN ports both use RJ-45 connectors. Use caution when connecting cables. Statement 1021
Danger
Hazardous network voltages are present in WAN ports regardless of whether power to the unit is OFF or ON.
To avoid electric shock, use caution when working near WAN ports. When detaching cables, detach the end
away from the unit first. Statement 1026
Danger
To prevent damage to the server, handle the server by the chassis or frame.
Caution
Before You Begin
Do the following:
1.
Using either a number-1 Phillips screwdriver or a small flat-blade screwdriver, unscrew the captive screws
and remove the blank faceplate from the chassis NIM slot that you want to use.
2.
Save the blank faceplates for future use.
3.
Connect a wrist-strap clip to an unpainted portion of the chassis frame to channel unwanted ESD voltages
to ground.
Procedure
Cisco UCS E-Series Servers and the Cisco UCS E-Series Network Compute Engine Hardware Installation Guide
57
Installing the NIM E-Series NCE into the Router
