5-5
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
78-16778-01
Chapter 5 Setting Up Discovery and Device Management
Adding Device Credentials to the WLSE
Enter Telnet or SSH Credentials for IOS Access Points
Telnet/SSH credentials are used for downloading configuration files to IOS-based
access points and for upgrading firmware on IOS access points.
Note
When entering Telnet or SSH credentials, enter data only in the fields that
correspond to the login sequence on the access point(s). For example, if the access
point does not prompt for a user name, do not enter a user name.
To enter Telnet or SSH credentials, perform the following steps:
Step 1
Select
Devices > Discover > Device Credentials > Telnet/SSH User/Password
.
Step 2
To add a username and password:
a.
Enter the access point IP address or range of IP addresses that will use this
username and these passwords.
b.
Enter the username.
c.
Enter the password and confirm it.
d.
Enter the enable password and confirm it.
e.
Click
Save
. The IP address, username, and passwords are added to the
Current Entries textbox.
Step 3
Repeat step 2 to add credentials for more devices.
