Cisco CGR 1240, Инструкция по монтажу

Страница: 6 / 26

54
Materials and Tools You Supply
You must supply some or all of these items to mount the router on a pole. The items you supply depends on the
installation procedure that you use.
Mounting Instructions
This section includes all the procedures required to mount the router on any supported pole type.
This section covers the following procedures:

Router Orientation, page 54

Install the Mounting Plate onto a Pole, page 54

Attach the Mounting Bracket to the Mounting Plate, page 59

Install the Router onto the Mounting Bracket, page 62

Mounting the Router onto a Wall, page 66
Router Orientation
When mounting the router on a pole, ensure that:

The router is oriented with the chassis cabling openings pointing down so the router cables can be correctly
connected through the openings and so the router door opens correctly, as shown in
Figure 35 on page 62 .

The router is mounted with the hinged access cover facing out.
Install the Mounting Plate onto a Pole
This section describes three different procedures for installing the mounting plate on a pole. Follow the instructions for
the pole type used in your installation.
The instructions in these section refer to the mounting plate features shown in Figure 27 on page 55 .

Install the Mounting Plate—Poles Up to 4.5 Inches in Diameter, page 55

Install the Mounting Plate—Poles Larger than 4.5 Inches in Diameter, page 57
Item Required for These Procedures
13-mm box-end wrench or socket set Install the Mounting Plate—Poles Up to 4.5 Inches in Diameter, page 55
Install the Mounting Plate—Through-Pole Mounting (Optional), page 58
Attach the Mounting Bracket to the Mounting Plate, page 59
Bolt, standard washer, fender washer, and nut,
5/8 inch (2 sets)—Bolt length depends on the size
of the pole used in the installation. Install the Mounting Plate—Through-Pole Mounting (Optional), page 58
Drill and drill bit Install the Mounting Plate—Through-Pole Mounting (Optional), page 58
Phillips screwdriver, or other screwdriver for
cross-recessed screws Ground the Router, page 70
Install the Optional Security Panel, page 63
Crimping tool or pliers Ground the Router, page 70