As with all the outdoor installations, you must install the antenna with cables exiting downward which helps
prevent water from accumulating around the cable exit points.
Caution
Required Tools and Equipment
IMPORTANT SAFETY INSTRUCTIONS Before you work on any equipment, be aware of the hazards
involved with electrical circuitry and be familiar with standard practices for preventing accidents. Read the
installation instructions before using, installing, or connecting the system to the power source. Use the statement
number provided at the end of each warning statement to locate its translation in the translated safety warnings
for this device.SAVE THESE INSTRUCTIONS Statement 1071
Danger
Only skilled person should be allowed to install, replace, or service this equipment. Refer to Statement
1089 for description of skilled person.
Statement 1090
Danger
To reduce the risk of electric shock, refer to national and local codes for proper installation and
grounding of antennas.
Statement 1052
Danger
To reduce the risk of electric shock, the chassis of this equipment needs to be connected to permanent
earth ground during normal use.
Statement 0445
Danger
The fasteners and the mounting surface should be capable of maintaining a minimum pullout force of 150
pounds (68 kg) to support the weight of the antenna and bracket, along with the potential wind loading on the
antenna.
Caution
The pole or mast must be rigid enough to hold the weight of the antenna along with the associated forces
produced by wind loads. Also, the pole or mast must be structurally strong enough to withstand the clamping
force of the hose clamps.
Caution
Before you mount the antenna, go through the supported mounting procedures and ensure that you have all
tools and fasteners mentioned therein ready. The following is a general list of fasteners and tools not included
in the antenna and brackets kit:
• To mount the antenna on a wall or ceiling, you need four mounting M8 screws or bolts and wall anchors.
• To mount the antenna on a pole or mast, you may need either or both of these supplies:
Introduction to Cisco Catalyst 9130 Access Point with 9104 Stadium Antenna
13
Introduction to Cisco Catalyst 9130 Access Point with 9104 Stadium Antenna
Required Tools and Equipment
