Cisco Catalyst 3650 Series, Справочник по командам

Страница: 585 / 1108

snmp-server engineID
To configure a name for either the local or remote copy of SNMP, use the snmp-server engineID command
in global configuration mode.
snmp-server engineID
{
local engineid-string
|
remote ip-address
[
udp-port port-number
] engineid-string }
Syntax Description
Specifies a 24-character ID string with the name of the copy of SNMP. You
need not specify the entire 24-character engine ID if it has trailing zeros.
Specify only the portion of the engine ID up to the point where only zeros
remain in the value.
local engineid-string
Specifies the remote SNMP copy. Specify the ip-address of the device that
contains the remote copy of SNMP.
remote ip-address
(Optional) Specifies the User Datagram Protocol (UDP) port on the remote
device. The default is 162.
udp-port port-number
Command Default
None
Command Modes
Global configuration
Command History
Modification Release
This command was introduced. Cisco IOS XE 3.3SECisco IOS XE 3.3SE
Usage Guidelines
None
Examples
The following example configures a local engine ID of 123400000000000000000000:
Device(config)# snmp-server engineID local 1234
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
559
snmp-server engineID