Cisco Catalyst 3650 Series, Справочник по командам

Страница: 357 / 1108

rep preempt delay
To configure a waiting period after a segment port failure and recovery before REP VLAN load balancing is
triggered, use the
rep preempt delay command in interface configuration mode. To remove the configured
delay, use the no form of this command.
rep preempt delay seconds
no rep preempt delay
Syntax Description
Number of seconds to delay REP preemption. The range is from 15 to 300 seconds.
The default is manual preemption without delay. seconds
Command Default
REP preemption delay is not set. The default is manual preemption without delay.
Command Modes
Interface configuration (config-if)
Command History
Modification Release
This command was introduced Cisco IOS XE Denali 16.2.2
Usage Guidelines
You must enter this command on the REP primary edge port.
You must enter this command and configure a preempt time delay if you want VLAN load balancing to
automatically trigger after a link failure and recovery.
If VLAN load balancing is configured, after a segment port failure and recovery, the REP primary edge port
starts a delay timer before VLAN load balancing occurs. Note that the timer restarts after each link failure.
When the timer expires, the REP primary edge alerts the alternate port to perform VLAN load balancing
(configured by using the
rep block port interface configuration command) and prepares the segment for the
new topology. The configured VLAN list is blocked at the alternate port, and all other VLANs are blocked
at the primary edge port.
You can verify your settings by entering the show interfaces rep privileged EXEC command.
Examples The following example shows how to configure a REP preemption time delay of 100 seconds on the primary
edge port.
Device(config)# interface TenGigabitEthernet 4/1
Device(config-if)#
rep preempt delay 100
Command Reference, Cisco IOS XE Everest 16.5.1a (Catalyst 3650 Switches)
331
rep preempt delay