Cisco Catalyst 3560, Руководство по установке оборудования

Страница: 44 / 168

Chapter 1 Using Express Setup
Rerunning Express Setup
1-12
Catalyst 3560 Switch Hardware Installation Guide
78-16057-01
Rerunning Express Setup
If you did not click Save at the end of the Configuring the Switch Settings section,
you can rerun Express Setup by clicking Express Setup on the Switch home page.
If you have entered a wrong IP address or need to change the IP address of your
switch, you can clear the IP address on your switch by following the steps in the
“Clearing the Switch IP Address and Configuration” section on page 4-2 .
Where to Go Next
After you have saved your configuration to the switch, you can install the switch
or further configure it by using CMS or the CLI.
Other Switch Home Page Features
These additional features are available from the switch home page, as shown on
the left menu bar in
Figure 1-8 on page 1-11 :
• Cluster Management Suite—Launch the CMS, through which you can
configure and monitor a switch or switch clusters, display network topologies
to gather link information, and display switch images to modify switch- and
port-level settings. For more information, refer to the switch software
configuration guide
•
Tools—Access diagnostic and monitoring tools such as Telnet and Extended
Ping.
•
Help Resources—Access Catalyst 3560 documentation.
Installing or Connecting Devices to the Switch
For detailed installation procedures on mounting your switch on or under a desk
or on a wall or connecting devices to the switch, see
Chapter 3, “Switch
Installation.”