Cisco Catalyst 3560-X Series, Руководство по настройке программного обеспечения

Страница: 1091 / 1538

1-45
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
OL-25303-03
Chapter 1 Configuring IP Unicast Routing
Configuring BGP
Figure 1-4 EIGRP Stub Router Configuration
For more information about EIGRP stub routing, see “Configuring EIGRP Stub Routing” section of the
Cisco IOS IP Configuration Guide, Volume 2 of 3: Routing Protocols, Release 12.4 .
Monitoring and Maintaining EIGRP
You can delete neighbors from the neighbor table. You can also display various EIGRP routing statistics.
Table 1-8 lists the privileged EXEC commands for deleting neighbors and displaying statistics. For
explanations of fields in the resulting display, see the Cisco IOS IP Command Reference, Volume 2 of 3:
Routing Protocols, Release 12.4 .
Configuring BGP
The Border Gateway Protocol (BGP) is an exterior gateway protocol used to set up an interdomain
routing system that guarantees the loop-free exchange of routing information between autonomous
systems. Autonomous systems are made up of routers that operate under the same administration and
that run Interior Gateway Protocols (IGPs), such as RIP or OSPF, within their boundaries and that
interconnect by using an Exterior Gateway Protocol (EGP). BGP Version 4 is the standard EGP for
interdomain routing in the Internet. The protocol is defined in RFCs 1163, 1267, and 1771. You can find
detailed information about BGP in
Internet Routing Architectures, published by Cisco Press, and in the
“Configuring BGP” chapter in the Cisco IP and IP Routing Configuration Guide .
Host A Host B
Switch B Switch A
Routed to WAN
Switch C
Host C
145776
Table 1-8 IP EIGRP Clear and Show Commands
Command Purpose
clear ip eigrp neighbors [ if-address | interface ] Delete neighbors from the neighbor table.
show ip eigrp interface [ interface ] [ as numbe r] Display information about interfaces configured for EIGRP.
show ip eigrp neighbors [ type-number ] Display EIGRP discovered neighbors.
show ip eigrp topology [ autonomous-system-number ] |
[[ ip-address ] mask ]]
Display the EIGRP topology table for a given process.
show ip eigrp traffic [ autonomous-system-number ] Display the number of packets sent and received for all or a
specified EIGRP process.