3-4
Cisco Broadband Access Center for Cable Installation Guide 2.7
OL-19105-01
Chapter 3 Installing Components
Installing Components Using the Graphical User Interface
Installing Extensions
Before you install the Network Registrar extensions, complete the steps described in the
“Installation
and Startup Process” section on page 2-2
. To install the extensions:
Step 1
On the Installation Components screen, select the Cisco Network Registrar extension points option, then
click
Next
to continue; the Home Directory Destination screen appears.
Note
The installation program now validates your Network Registrar (CNR) installation. We
recommend that you have CNR version 6.1.2.3 or higher. If the required version is not installed,
the installation process is terminated and you must upgrade to the required Network Registrar
version before proceeding.
Step 2
Enter the pathname for the home directory, or click the
Browse
button to locate the desired directory.
Note
The installation program does not ask for the home directory when it identifies that you are
installing BACC components on a computer that already has a BACC component installed on it.
Step 3
Click
Next
. The installation program performs some validation and, prompts you to create the directory,
if necessary, before the Data Directory Destination screen appears.
Step 4
Accept the default directory or enter a new directory. You can use the
Browse
button to select a new
directory.
Note
By default, the installation program installs the data directory (BPR_DATA) on a different
directory than the home directory (BPR_HOME). Cisco Systems recommends that the data
directory be on a different physical disk than the home directory; for example,
/var/disk0/CSCObpr. However, you can install the data directory on the same disk as the home
directory.
Step 5
Click
Next
. The Regional Distribution Unit Host/Port screen appears.
Step 6
Enter the IP address (or hostname) and the listening port of the host where the RDU software is installed.
By default, the name of the local host appears in the RDU IP Address field. The RDU uses the listening
port to communicate with the DPEs and Network Registrar extension points.
Step 7
Click
Next
. The Cisco Network Registrar Extension Point Provisioning Group screen appears.
Step 8
Enter the name of the extension point provisioning group.
Step 9
Click
Next
. The PacketCable Panel screen appears.
Step 10
Determine if you need to install the voice technology option and click:
•
Yes
button if you want to install the voice technology option. The PacketCable Properties screen
appears.
•
No
if you do not have a valid license key for this technology. After clicking
No
, go to step
number 12.
Step 11
Enter the appropriate information into the fields shown.