4-5
Cisco ATA 190 Analog Telephone Adaptor Administration Guide for SIP (Version 1.0)
OL-31821-01
Chapter 4 Configuring the ATA 190
Configuring Product Specific Configuration Parameters
Table 4-3
lists the configuration parameters you can set using Cisco Unified Communications Manager
Administration.You can set the configuration parameters using any of the three configuration windows
listed in
Table 4-2
.
When you set the parameters, select the Override Common Settings check box for each setting you wish
to update. If you do not check this box, the corresponding parameter setting does not take effect.
Note
Some ATA 190 parameters are set from port 1 only. Setting the parameters from port 2 will have no
effect. Set the following parameters from port 1 only—IVR Password, Phone Load Name, CDP, and Web
Access.
Table 4-3
Configuration Parameters for the ATA 190
Parameter
Description
Auto Barge
Auto Barge adds a user to an active call. An offhook phone
automatically adds the user (initiator) to the shared line call
(target), and the users currently on the call receive a tone (if
configured). Barge supports built-in conference and shared
conference bridges.
The Auto Barge feature allows the user to go offhook and be
added to the call. The Auto Barge feature supports built-in
conferences and shared conference bridges.
Call Sequence
•
Bellcore FSK
•
ETSI FSK
Caller ID
•
BT FSK
•
Bellcore FSK
•
ETSI FSK
Cisco Discovery Protocol (CDP)
Enable or disable the CDP function of the ATA 190
Fax Error Correction Mode Override
You can set the fax error correction mode override values to
one of the following settings:
•
Default
•
On
•
Off
Fax Mode
The Cisco ATA supports two fax modes:
•
Fax Pass–Through—Allows fax and modem traffic to
pass through a voice port
•
T.38 Fax Relay—Allows for a more robust protocol for
fax transmission over packet networks
•
NSE Fax pass–Through—g711ulaw
•
NSE Fax pass–Through—g711alaw
Hookflash Timer
(100 ms to 1500 ms)
Hookflash Timer
The time to validate hookflash event.
Impedance
The ATA 190 provides multiple impedance values, such as
600 ohm for use in the United States
