bundle port-priority
To configure Link Aggregation Control Protocol (LACP) priority for a port , enter the
bundle port-priority
command in interface configuration mode. To return to the default LACP priority value, use the
no
form of
this command.
bundle port-priority priority
no bundle port-priority priority
Syntax Description
Priority for this port, where a lower value equals a higher priority. Replace the
priority
argument with a number. Range is from 1 through 65535.
priority
Command Default
priority
: 32768
Command Modes
Interface configuration
Command History
Modification
Release
This command was introduced.
Release 3.7.2
Usage Guidelines
To use this command, you must be in a user group associated with a task group that includes appropriate task
IDs. If the user group assignment is preventing you from using a command, contact your AAA administrator
for assistance.
The LACP priority value forms part of the port ID, which is transmitted within the LACP packets that are
exchanged with the peer. The peer uses the LACP packets to determine whether a given port should carry
traffic for the bundle.
For Multi-Gigabit Service Control Point (MGSCP), the
bundle port-priority
command applies to working
links.
A lower LACP value is a higher LACP priority for the port.
Note
Task ID
Operations
Task ID
read, write
bundle
Cisco ASR 9000 Series Aggregation Services Router Interface and Hardware Component Command Reference,
Release 5.3.x
583
Link Bundling Commands on the Cisco ASR 9000 Series Router
bundle port-priority