6-5
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Hardware Installation Guide
OL-14126-03
Chapter 6 Installing and Removing a Shared Port Adapter
Checking the Installation
Step 1
Observe the console display messages and verify that the system discovers the SIP, while the system
reinitializes each interface, as follows:
•
When a new SPA is inserted into the system, the default configuration will be used for the associated
interfaces.
•
As a SIP is initialized, the STATUS LED will first be amber, indicating that power is on, but the
SIP is being configured. When the SIP is active, the STATUS LED will illuminate green.
•
SPAs will follow the same sequence once the SIP has completed its initialization. The SPA
STATUS LEDs will illuminate amber, turning to green when the SPAs become active.
•
When the SIP and SPA STATUS LEDs are green, all associated interfaces are configurable.
Note
Refer to the
Cisco ASR 1000 Series Aggregation Services Routers SIP and SPA Software
Configuration Guide
for configuration instructions.
•
If a SIP or SPA is replaced with a module of the same type (as in an OIR or hardware swap), the
previous configuration will be reinstated when the SIP or SPA becomes active.
•
If a SIP or SPA has not been previously installed in the same slot or subslot, then the configuration
for all associated interfaces will be empty.
Note
New interfaces are not available until you configure them.
Step 2
If the SIPs and SPAs have not become active within three minutes, refer to the system console messages
as follows:
•
If a SIP or SPA is undergoing a field-programmable device (FPD) upgrade, then console messages
will indicate that the FPD process has been initiated. The upgrade process might take several
minutes. Use the
show upgrade fpd progress
command to obtain information about the FPD
process. SIPs or SPAs that undergo an FPD upgrade will automatically be rebooted. Return to
•
If there is no indication that an FPD upgrade is under way, see
Chapter 7, “Troubleshooting the
Using show Commands to Verify SIP and SPA Status
The following procedure uses
show
commands to verify that the new SPAs are configured and operating
correctly.
Step 1
Use the
show running-config
command to display the system configuration. Verify that the
configuration includes the new SPA interfaces.
Step 2
Display all of the current SPAs and a summary of their status using the
show hw-module subslot all oir
command.
Step 3
Display information about the installed SIPs using the
show diag
command.
Step 4
Use the
show hw-module subslot all fpd
command to verify the FPD version information of the SPAs
installed in the system.