482
Cisco Aironet 2.4 GHz and 5 GHz Dual-Band Polarization-Diverse Directional Array Antenna (AIR-ANT2566D4M-R)
Deciding on a Mounting Location
The antenna should be mounted clear of any obstructions to the side or front of the enclosure, which contains the radiating
elements. Keep in mind that this antenna should be aimed at the intended coverage area. Therefore, you should mount the
antenna such that the desired mechanical tilt is achieved. If possible, mount the antenna near the access point so that you can
use the shortest possible connecting cables.
CAUTION:
For outdoor installations, install the antenna with cables exiting downward. This will help prevent water from
accumulating around the cable exit points.
Tools and Equipment Required
WARNING:
The fasteners and the mounting surface should be capable of maintaining a minimum pullout force of 150 pounds
(68 kg) to support the weight of the antenna and bracket along with the potential wind loading on the antenna.
WARNING:
The pole or mast must be rigid enough to hold the weight of the antenna along with the associated forces produced
by wind loads. Also, the pole or mast must be structurally strong enough to withstand the clamping force of the hose clamps.
Before you start with mounting the antenna, go through the mounting procedure for each kind of installation and ensure that you
have all tools and fasteners mentioned therein ready. The following is a general list of fasteners and tools which are not included
in the antenna and brackets kit.
To loosen and tighten the adjustment bolts on the brackets, you need a flat-blade screwdriver.
To mount the antenna on a wall or ceiling, you need four mounting 4 mm or #8 screws or bolts and wall anchors.
To mount the antenna on a pole or mast, you will need either or both of these supplies:
—
Slotted screwdriver to tighten the screws on the hose clamps
—
A 5/16 inch (8mm) socket or box wrench
You may also need the following tools and equipment, which are not provided as part of the kit:
—
A drill and drill bit
—
A pencil
—
A small mallet or hammer, to hammer
—
A Phillips screwdriver
Mounting on a Wall or Ceiling
1.
The fasteners and mounting surface should be capable of maintaining a minimum pullout force of 150 pounds (68 kg) to
support the weight of the antenna along with the potential wind loading on the antenna.
2.
Determine the mounting location for the antenna.
3.
Attach the free articulating mount flange to the wall or ceiling using four 4 mm or #8 screws and fasteners, through the
holes on the bracket.
One of the two required articulating mount flange brackets come attached to the back of the antenna (see
). The other
flange bracket, included in the kit, is the one used in this step.
1.
Assemble the bracket hardware, as shown in
. Use a flat blade screwdriver to tighten the 1/4 20 x 1.25" screws
on the brackets.
