Cisco Aironet 1250 Series, Руководство по установке оборудования, Страница: 36 / 142

2-8
Cisco Aironet 1250 Series Access Point Hardware Installation Guide
OL-8247-03
Chapter 2 Installing the Access Point
Mounting on a Horizontal or Vertical Surface
Step 2
Drill one of the following sized holes at the locations you marked:
• 3/16 in. (4.7 mm) if you are using wall anchors.
•
1/8 in. (6.3 mm) if you are not using wall anchors, you must attach the mounting plate to a stud or
major structural member and use appropriate length fasteners.
Step 3 Install the anchors into the wall if you are using them. Otherwise, go to Step 4.
Step 4
Secure the mounting plate to the surface using #8 fasteners.
Step 5 Optionally, you can install a 10 AWG copper ground wire to the mounting plate ground stud (see
Figure 2-2 ). The other end of the ground wire should be attached to a building ground connection point.
Step 6
Route your cables through the mounting plate openings or through the ends of the mounting plate.
Step 7 Optionally, you can secure your cables using the supplied tie-wraps and the mounting plate tie points.
Step 8
Connect your cables to the access point connectors (see Figure 2-1 ) before attaching the access point to
the mounting plate (see the “Connecting the Ethernet and Power Cables” section on page 2-20 ).
Step 9 Prior to attaching the access point to the mounting plate, ensure that the radio modules are completely
inserted and both module latches are in the locked position (see
Figure 2-24 ).
Step 10
Attach the access point to the mounting plate (see “Mounting Plate Attached to a Surface” section on
page 2-26 ).
Step 11 If you need additional security, refer to the “Securing the Access Point” section on page 2-27 for
additional information.
Step 12
Verify the access point is operating (see the “Powering Up the Access Point” section on page 2-22 ).