9
6
Preparing the AP for Installation
Before you mount and deploy your access point, we recommend that you perform a site survey (or use
the site planning tool) to determine the best location to install your access point.
You should have the following information about your wireless network available:
•
Access point locations.
•
Access point mounting options: vertically oriented, on a wall or a desk.
•
Powered by 802.3af or 802.3at, through PoE from a network device or a PoE power injector or
hub (usually located in a wiring closet).
Note
Access points mounted in a building’s environmental airspace must be powered using PoE
to comply with safety regulations.
Cisco recommends that you make a site map showing access point locations so that you can record the
device MAC addresses from each location and return them to the person who is planning or managing
your wireless network.
7
Installation Overview
During installation, gently adjust the module and radio unit such that the internal connectors are
aligned and centered. Now, gently snap them into place.
Caution
To assemble the module and radio unit, do not use excessive force. This will prevent
irreversible physical connector damage.
Installing the access point involves these operations:
Step 1
Performing a Pre-Installation Configuration, page 10
(optional)
Step 2
Mounting and Powering the Access Point, page 13
Step 3
