Connecting the Router
This chapter describes how to connect the Cisco 809 Integrated Services Router to Ethernet devices and a
network.
•
Preventing Damage to the Router, on page 1
•
Connecting a Terminal or PC to the Console Port, on page 2
•
Connecting to DC Power, on page 2
•
Connecting the Router to the AC-Input Power Supply, on page 5
•
Connecting the Router to the DC Source., on page 6
•
Connecting the Power Converter to an AC Power Source, on page 8
•
Verifying Connections, on page 10
Preventing Damage to the Router
Before installation, observe these general guidelines:
• Proper ESD protection should be observed.
• Ensure the router is properly grounded.
• Ensure there is proper airflow around the router.
If you must supply your own cable, see the
for cabling specifications. If this appendix
does not provide specifications for a particular cable, we strongly recommend ordering the cable from Cisco.
The intra-building ports of the equipment or subassembly is suitable for connection to intra-building or
unexposed wiring or cabling only. The intra-building port(s) of the equipment or subassembly MUST NOT
be metallically connected to interfaces that connect to the OSP or its wiring.These interfaces are designed for
use as intra-building interfaces only (Type 2 or Type 4 ports as described in GR-1089-CORE) and require
isolation from the exposed OSP cabling. The addition of Primary Protectors is not sufficient protection in
order to connect these interfaces metallically to OSP wiring.
Warning
The intra-building ports of the equipment or subassembly must use shielded intra-building cabling/wiring that
is grounded at both ends.
Warning
Connecting the Router
1