Cisco 7910 - IP Phone VoIP, Руководство по началу работы

Страница: 13 / 34

2-3
Getting Started with the Cisco IP Phone 7910 Series
78-11443-02
Chapter 2 Installing the Cisco IP Phone 7910 Series
Installing the Phone and Connecting to the Network
Installing the Phone and Connecting to the Network
Before installing the phone, read the safety warnings in the “Safety Notices”
section on page 2-1 .
Refer to Figure 2-1 for an overview about how to connect the
Cisco IP Phone 7910 Series telephone to your PC, the network, and a power
source. All ports are located at the rear of the phone base unit.
Figure 2-1 Cisco IP Phone 7910 Series Telephone Cable Connections
Use this procedure to install the phone on a network that has already been
prepared to host the phone.
Step 1
Connect an Ethernet cable to the network port on the phone.
Use the Ethernet cable supplied in the box with your Cisco IP phone. If you need
a longer cable, contact your system administrator.
Step 2 Connect the handset to its port. Clip the cord into the slot to the right of the port.
Handset plug
AC adapter port
(optional power cube)
RS-232 port
Access port
(Cisco IP phone 7910+SW only)
Network port
44729
Cisco IP phone 7910