Cisco 594, Руководство по установке, Страница: 30 / 84

3-2
Cisco Wide Area Virtualization Engine 594 and 694 Hardware Installation Guide
OL-24619-02
Chapter 3 Installing the WAVE-594 and WAVE-694
Rack Mounting and Cabling the WAVE-594 and WAVE-694
Caution
Always use filler panels to fill empty vertical spaces in the rack. This arrangement ensures proper
airflow. Using a rack without filler panels results in improper cooling that can lead to thermal damage.
•
Observe the following additional requirements to ensure adequate airflow and to prevent damage to
the equipment:
– Front and rear doors—If the 42U rack includes closing front and rear doors, you must allow
5,350 sq cm (830 sq in) of holes evenly distributed from top to bottom to permit adequate
airflow (equivalent to the required 64 percent open area for ventilation).
–
Side—The clearance between the installed rack component and the side panels of the rack must
be a minimum of 7 cm (2.75 in).
Note
Rack-mounting the WAVE-594 and WAVE-694 appliance is supported for rear mount in a 4-post rack or
front mount in a 2-post rack.
Table 3-1 lists the rack mounting hardware included in your shipping container. You will need a Phillips
screwdriver. Verify that you have received the following items for the installation:
Rack Mounting and Cabling the WAVE-594 and WAVE-694
There are two ways you can rack mount the WAVE appliance. The following topics are included in this
section:
• Mounting in a 4-Post Rack
•
Front-Mounting in a 2-Post Rack
• Cabling
Table 3-1 Rack Mount Hardware Provided
Item Name Description Qty
Rack Type
2-post 4-post
1 Front rack mount
bracket Front rack mount L bracket 2 X X
2 Rear rack mount
bracket holder Rear rack mount bracket holder 2 X
3 32” rear rack mount
bracket Rear rack mount bracket (32 inch) 2 X
4 Front rack mount
bracket screw Front rack bracket screw, #6-32 x 0.30”, Wafer
Head, Phillips, Steel w/ Zinc and Black 6 X X
5 Rear rack mount
bracket holder screw Rear bracket holder screw, M4 x0.7 x 4.85 mm,
120º, Flat Head, Phillips, Steel w/ Zinc and Black 6 X
6 Rack screw Rack screw, #10-32 x 0.50”, Truss Head, Phillips,
Steel w/ Ni and Black 8 X X
7 Rack screw Rack screw, M5 x 12.7 mm, Truss Head, Phillips,
Steel w/ Ni and Black 8 X