Cisco 3750 - Catalyst EMI Switch, Справочник по командам

Страница: 994 / 1154

B-22
Catalyst 3750 Switch Command Reference
OL-8552-07
Appendix B Catalyst 3750 Switch Debug Commands
debug lacp
debug lacp
Use the debug lacp privileged EXEC command to enable debugging of Link Aggregation Control
Protocol (LACP) activity. Use the no form of this command to disable debugging.
debug lacp [ all | event | fsm | misc | packet ]
no debug lacp [ all | event | fsm | misc | packet ]
Syntax Description
Defaults
Debugging is disabled.
Command Modes Privileged EXEC
Command History
Usage Guidelines The undebug lacp command is the same as the no debug lacp command.
When you enable debugging, it is enabled only on the stack master. To enable debugging on a stack
member, you can start a session from the stack master by using the
session switch-number privileged
EXEC command. Then enter the debug command at the command-line prompt of the stack member. You
also can use the remote command stack-member-number LINE privileged EXEC command on the stack
master switch to enable debugging on a member switch without first starting a session.
Related Commands
all (Optional) Display all LACP debug messages.
event (Optional) Display LACP event debug messages.
fsm (Optional) Display LACP finite state-machine debug messages.
misc (Optional) Display miscellaneous LACP debug messages.
packet (Optional) Display LACP packet debug messages.
Release Modification
12.1(14)EA1 This command was introduced.
Command Description
show debugging Displays information about the types of debugging that are enabled.
show lacp Displays LACP channel-group information.